Fortinet Technologies Inc. Page 33 FortiVoice 200D/200D-T v2.0 MR1 CLI Reference
trunk-out <name> Enter the SIP trunk name for the outbound calls.
<No.> Enter a record number for the dial pattern.
pattern <string> Enter the number pattern for this dial plan.
For information on pattern-matching syntax and pattern-
matching examples, see “pbx number-management” on
page 57.
postfix <string> Add a number after a pattern.
For example, if your pattern is 9XXX and the numbers
under this pattern have been upgraded to have an
additional digit 5 at the end, you can enter 5 for the
Postfix. When an incoming call matches the pattern,
the FortiVoice unit will add a 5 after the number.
prefix <string> Add a number before a pattern.
For example, if your pattern is 9XXX and the numbers
under this pattern have been upgraded to have an
additional digit 5 at the beginning, you can enter 5 for the
Prefix. When an incoming call matches the pattern, the
FortiVoice unit will add a 5 before the number.
strip-digits <integer> Enter a number to omit dialing the starting part of a
pattern. 0 means no action.
For example, if your pattern is 222XXXX and Strip-
digits is 3, the FortiVoice unit will only dial the last four
digits for all called numbers matching the pattern.
0
<No.> Enter a record number for the caller ID pattern.
number-pattern <string> Enter the caller ID pattern for this dial plan.
You can enter a caller’s display name string or the caller’
phone number string as the pattern.
Callers with IDs under this pattern are subject to this
plan.
Create the number pattern following the pattern-
matching syntax and pattern-matching examples in “pbx
number-management” on page 57.
status {enable | disable} Enable or disable this dial plan. enable
option <emergency-call> Set to allow emergency call with this plan.
Variable Description Default
To Next Page
Loading...
