Fortinet FortiVoice 200D - Page 96

Fortinet Technologies Inc. Page 96 FortiVoice 200D/200D-T v2.0 MR1 CLI Reference
allowaccess {ping | http |
https | snmp | ssh | telnet}
Enter one or more of the following protocols to add them
to the list of protocols permitted to administratively
access the FortiVoice unit through this network interface:
• ping: Allow ICMP ping responses from this network
interface.
• http: Allow HTTP access to the web-based manager
and user web portal.
Caution: HTTP connections are not secure and can
be intercepted by a third party. To reduce risk to the
security of your FortiVoice unit, enable this option
only on network interfaces connected directly to your
management computer.
• https: Allow secure HTTP (HTTPS) access to the
web-based manager and user web portal.
• snmp: Allow SNMP v2 access.
• ssh: Allow SSH access to the CLI.
• telnet: Allow Telnet access to the CLI.
Caution: Telnet connections are not secure and can
be intercepted by a third party. To reduce risk to the
security of your FortiVoice unit, enable this option
only on network interfaces connected directly to your
management computer.
Varies by
the network
interface.
ip <ipv4mask> Enter the IP address and netmask of the network
interface.
ip6 <ipv6mask> Enter the IPv6 address and netmask of the network
interface.
mode {static | dhcp} Enter the interface mode. static
mtu <mtu_int> Enter the maximum packet or Ethernet frame size in
bytes.
If network devices between the FortiVoice unit and its
traffic destinations require smaller or larger units of
traffic, packets may require additional processing at
each node in the network to fragment or defragment the
units, resulting in reduced network performance.
Adjusting the MTU to match your network can improve
network performance.
The valid range is from 576 to 1500 bytes.
1500
speed {auto | 10full |
10half | 100full |
100half | 1000full
|1000half}
Enter the speed of the network interface.
Note: Some network interfaces may not support all
speeds.
auto
status {down | up} Enter either up to enable the network interface to send
and receive traffic, or down to disable the network
interface.
up
Variable Description Default