Frequently Asked Questions
Operating Problems
Wrist PDA User Guide 135
Operating Problems
I do not see anything on the Wrist PDA screen.
Your watch may be set to “sleep” with the screen off, or the batteries
may need charging.
• Press and hold the Rocker switch for several seconds. If the
display resumes, your Watch Mode App is set to None. You
can change this setting in the Wrist PDA preferences.
• Recharge your Wrist PDA. If your batteries are too low, the
screen will turn off to conserve power.
• If the display does not come back on after charging is
complete, try performing a soft reset as described in the next
section.
How do I reset the watch?
If your watch stops responding to the stylus or control buttons, you
may need to perform a reset. See page 131.
How do I open the software keyboard?
The keyboard is accessible as an icon on the command bar. Open the
command bar by making a command stroke (a diagonal stroke from
the lower left to the upper right) while the blinking text entry cursor
appears.
The command bar will remain open for 3 seconds. While the
command bar is open, tap the keyboard icon.
You can also open the keyboard tapping the tab in the upper-left
corner of the screen; select Edit, Keyboard.
The software keyboard beeps, but does not
display.
The software keyboard opens if there is a blinking text entry cursor
in an area where text can be entered. Tap in the area where you wish
to enter text. When you see a blinking cursor, try to open the
keyboard again.