Installing Palm Desktop Software
Installing the Wrist PDA Software
124 Wrist PDA User Guide
4. Find the folder that contains the information for your old Palm
OS device. Its name should be similar to the device's HotSync
user name.
5. Inside this folder are directories called address, todo, datebook,
and memopad. Copy these folders and paste them into the "old
device" directory that you created in step 3
6. Install the Wrist PDA Palm Desktop software by following the
directions in the next section. Be sure to create a unique user name
for your new Wrist PDA watch during step7 of the installation
process.
7. After all of the software is installed, go to your "old device"
directory and copy the address, todo, datebook, and memopad
folders (not the backup folder).
8. Paste the folders into the directory that uses your new Wrist PDA
user name that was created during the software installation.
9. Perform a HotSync operation using your Wrist PDA (see page
111). The Address Book, To Do List, Memo, and Datebook records
from your previous handheld will now be copied to your Wrist
PDA.
Installing the Wrist PDA Software
Follow these steps to install the required Wrist PDA software:
• Palm Desktop software
• HotSync Manager
• Wrist PDA COM Port Manager
• Wrist PDA HotSync Pod USB Drivers
IMPORTANT: If you already own an existing Palm OS device,
see “Importing Data From an Existing Palm OS Device” on page
123 to import your existing Palm OS data to your Wrist PDA.
1. Exit all running programs. Be sure that Microsoft
®
Outlook
®
is
closed before you begin the installation.
To Next Page
Loading...
Need help?
General