When setting up the Robacta TC and cleaning unit, ensure an all-round clearance
of at least 0.5 m (19.69 in.) from any surrounding objects, e.g. walls, other
devices or objects.
The Robacta TC and the cleaning unit must be set up at least 1 m (40 in.) away
from computers, control lines and the welding process.
Position the Robacta TC and cleaning unit to prevent welding spatter coming into
contact with the cleaning device.
Before transporting the device, allow parting agent to drain completely.
When transporting the device, observe the relevant national and local guidelines
and accident prevention regulations. This applies especially to guidelines regard-
ing the risks arising during transport.
After transporting the device, the device must be visually inspected for damage
before commissioning. Any damage must be repaired by trained service techni-
cians before commissioning the device.
Safety measures
in normal opera-
tion
Only operate the device when all safety devices are fully functional. If the safety
devices are not fully functional, there is a risk of
-
injury or death to the operator or a third party,
-
damage to the device and other material assets belonging to the operator,
-
inefficient operation of the device.
Any safety devices that are not functioning properly must be repaired before
switching on the device.
Never bypass or disable safety devices.
Before switching on the device, ensure that no one is likely to be endangered.
Check the device at least once a week for obvious damage and proper function-
ing of safety devices.
-
Only use suitable original parting agent from the manufacturer.
-
Observe the information on the parting agent safety data sheets when hand-
ling parting agent. The parting agent safety data sheets may be obtained
from your service centre or downloaded from the manufacturer's website.
-
Do not mix the manufacturer's parting agent with other parting agents.
-
If damage results from using a different parting agent, the manufacturer ac-
cepts no liability. In addition, no warranty claims will be entertained.
-
Used parting agent must be disposed of properly in accordance with the rel-
evant national and international regulations.
Maintenance and
repair
Under normal operating conditions, the device requires only a minimum of care
and maintenance. However, it is vital to observe some important points to ensure
it remains in a usable condition for many years.
-
Before switching on, always check the mains plug and cable as well as char-
ger leads and charging terminals for any signs of damage.
-
If the surface of the device housing is dirty, clean with a soft cloth and
solvent-free cleaning agent only
Maintenance and repair work must only be carried out by authorised personnel.
Use only original replacement and wearing parts (also applies to standard parts).
It is impossible to guarantee that bought-in parts are designed and manufac-
tured to meet the demands made on them, or that they satisfy safety require-
ments.
11
EN
To Next Page
Loading...
Need help?
General