Fronius Robacta TC 1000 - Cleaning Programme Overview; Cleaning Programme Sequences

Cleaning programme
Overview of pro-
gram sequence
with dipping
bowl
1.
Welding
2.
Cooling torch in dipping bowl
3.
Cleaning gas nozzle tip
4.
Welding
5.
Cooling torch in dipping bowl
6.
Cleaning the nozzle fitting
7.
Welding
Overview of pro-
gram sequence
with parting
agent nebuliser
1.
Welding
2.
Cleaning gas nozzle tip
3.
Spraying in parting agent
4.
Welding
5.
Cleaning the nozzle fitting
6.
Spraying in parting agent
7.
Welding
Overview of pro-
gram sequence
with parting
agent nebuliser
and dipping bowl
1.
Welding
2.
Cooling torch in dipping bowl
3.
Cleaning gas nozzle tip
4.
Spraying in parting agent
5.
Welding
6.
Cooling torch in dipping bowl
7.
Cleaning the nozzle fitting
8.
Spraying in parting agent
9.
Welding
Cooling welding
torch in the dip-
ping bowl - de-
tailed descrip-
tion
Immersing the hot welding torch in the "Robacta TC Cool / Robacta TC Cool MD"
parting agent has the following benefits:
-
The spatter that has accumulated on the gas nozzle is loosened
-
The welding torch is cooled down more
-
The anti-adhesive agent in the "Robacta TC Cool / Robacta TC Cool MD"
parting agent prevents renewed soiling
max. 75 mm
(2.95 in.)
(1)
1
After welding, position the welding
torch approximately 50 mm (1.97
in.) above the dipping bowl
NOTE!
Do not dip the welding torch more
than 75 mm (2.95 in.) into the dipping
bowl. The gas holes (1) must remain
dry.
2
Dip the welding torch vertically in-
to the dipping bowl
65
EN