Bolting the Robacta TC 1000 to the underlying
surface (foundation)
Bolting the
Robacta TC
1000 together
with installation
stand to the un-
derlying surface
(foundation)
WARNING!
Danger from machines toppling over or falling.
This can result in serious personal injury and damage to property.
▶
The cleaning device should only ever be set up with the designated installa-
tion stand.
▶
Different fixings may be required to connect the installation stand to the un-
derlying surface depending on the nature of the surface.
▶
The fixings required to connect the installation stand to the underlying sur-
face are not included in the scope of supply of the installation stand. The in-
staller is responsible for selecting the right type of fixing. Only the screws
needed to fit the cleaning device to the installation stand are supplied with
the stand itself.
1
Place the optionally available installation stand on a level, firm and vibration-
free surface
-
Position the installation stand in such a way that the distance the robot
has to travel to the cleaning device on the installation stand is as short as
possible
2
Screw the installation stand to the underlying surface using the appropriate
fixings
3
Position the cleaning device on the
installation stand
4
Screw the cleaning device to the
installation stand using the 4
screws supplied with the stand
44
To Next Page
Loading...