Base unit and cleaning unit S.
Base unit and
cleaning unit S.
(9)
(8)
(7)
(6)
(5)
(4)
(4)(2)(1)
(10)(11)
(3)
(1) Cleaning unit S.
(2) Cleaning opening with internal parting-agent injection nozzle and brush
seal
for cleaning the gas nozzle and the inside of the welding torch
for coating the gas nozzle and welding torch interior with parting agent
NOTE!
To avoid excess soiling, only use the device with the brush seal in place.
(3) Fastening nuts
for attaching an optional wire cutter
(4) Fastening nuts
for fixing the cleaning unit in place
(5) Spray device connection
for connecting to the parting agent nebuliser; for spraying the com-
pressed air/parting agent mixture into the cleaning opening
If a parting agent nebuliser is not used, connect parting agent nebuliser
connection (8) to spray device connection (5). Use the supplied com-
pressed air connecting hose for this purpose.
(6) Compressed air connection
for supplying the cleaning device with compressed air
(7) Wire cutter connection socket
for electrically controlling the wire cutter
34
To Next Page
Loading...