Scope of supply and options
General The cleaning devices can be used in conjunction with various options. This makes
it possible to optimise various procedures in the welding process, as necessitated
by the particular field of application.
Robacta TC
1000 scope of
supply
-
Robacta TC 1000 with dipping bowl and integral cleaning unit
-
Standard I/O connecting plug (X1) without cable
-
Compressed air interconnecting hosepack
Robacta TC
1000 options
Available options for the Robacta TC 1000
-
Installation stand (available in various heights)
-
Wire cutter
-
Wire cutter installation kit
-
Installation kit for parting agent nebuliser / parting agent nebuliser V
-
Auto-transformer for 110 V and 400 V mains voltage
-
Robot interface
Robacta TC
1000 ext. scope
of supply
-
Base unit (Robacta TC 1000 ext.)
-
Standard I/O connecting plug (X1) without cable
-
Compressed air interconnecting hosepack
NOTE!
Cleaning units S. and P. are not included in the base unit scope of supply,
however they are needed in order to use the device.
Robacta TC
1000 ext. op-
tions
Available options for the Robacta TC 1000 ext.
-
Cleaning unit S.
-
Cleaning unit P.
-
Installation stand (available in various heights)
-
Auto-transformer for 110 V and 400 V mains voltage
-
Robot interface
-
Installation stand for cleaning units S. and P.
-
Wire cutter
-
Installation kit for parting agent nebuliser / parting agent nebuliser V
23
EN
To Next Page
Loading...