Fronius Robacta TC 1000 - Component Identification and Connections

To Next Page

To Previous Page

Robacta TC 1000

Robacta TC

1000 connec-

tions and mech-

anical compon-

ents

(2)

(3)

(4)

(5)

(1)

Front of device

(8)

(7)

(6)

(10)

(9)

(11)

(12)

(7)

(13)

Rear of device

(1) Level sensor

monitors the parting agent fill level in the dipping bowl

(2) Blanking cover

(3) Standard I/O connection socket (X1)

(4) Mains cable with strain relief device

(5) Spatter tray for welding residues (in optional installation stand)

(6) Cleaning opening with internal parting-agent injection nozzle and brush

seal

for cleaning the gas nozzle and the inside of the welding torch

for coating the gas nozzle and welding torch interior with parting agent

NOTE!

To avoid excess soiling, only use the device with the brush seal in place.

(7) Recesses for the wire cutter holder

for attaching the wire cutter holder to the cleaning device

(8) Drain hose

for emptying the dipping bowl

(9) Compressed air connection

for supplying the cleaning device with compressed air