Filling the dipping bowl with parting agent
Filling the dip-
ping bowl with
parting agent
NOTE!
Only use the "Robacta TC Cool +" parting agent supplied by the manufacturer.
The composition of the manufacturer's parting agent is intended specifically for
the Robacta TC. If other manufacturers' products are used, trouble-free opera-
tion cannot be guaranteed.
1
Fold out the container holder containing the empty "Robacta TC Cool +"
parting agent container
2
Remove the empty "Robacta TC Cool +" parting agent container and dispose
of it according to national regulations
3
Open a new "Robacta TC Cool +" parting agent container and put it into the
holder
4
Fold the container holder containing the full "Robacta TC Cool +" parting
agent container carefully back above the dipping bowl
-
The optimum fill-level is regulated automatically
NOTE!
Carry out the following maintenance on the dipping bowl at weekly intervals:
▶
Take the spill tray out of the dipping bowl and dispose of any accumulated
dirt
▶
Check the consistency of the "Robacta TC Cool +" parting agent. If the
"Robacta TC Cool +" parting agent is thick, add fresh water and stir to mix in
▶
Check the level sensor in the dipping bowl for dirt and clean if necessary
NOTE!
Carry out the following maintenance on the dipping bowl every three months:
▶
Drain all the parting agent from the dipping bowl
▶
Take the spill tray out of the dipping bowl and dispose of any accumulated
dirt
▶
Clean the dipping bowl and spill tray
▶
Fill the dipping bowl with new parting agent
Take care never to damage the level sensor when performing maintenance work.
51
EN
To Next Page
Loading...