Fronius Robacta TC 1000 - Starting up the Parting Agent Nebuliser

Starting up the
parting agent
nebuliser
NOTE!
Only use "Robacta Reamer" parting agent supplied by the manufacturer.
The composition of the manufacturer's parting agent is intended specifically for
the Robacta TC. If other manufacturers' products are used, trouble-free opera-
tion cannot be guaranteed.
1
Open the sealing plug (1)
2
Fill with "Robacta Reamer" parting agent using the funnel (2)
3
Close the sealing plug (1)
NOTE!
If the spray amount is not sufficient, increase it as required
▶
by adjusting the spray time using the robot control - a spray time of ~ 0.7
seconds is recommended
▶
or by using the parting agent adjuster (4): remove the safety clamp (3), use a
screwdriver to set the parting agent adjuster (4) so that the welding torch in-
terior is coated with a thin layer of parting agent (0.2-0.5 ml) after the spray-
ing action is complete
321
(1)
(1)
(4) (3)
(2)
53
EN