Installing and commissioning the parting agent
nebuliser (only for Robacta TC 1000)
Installing the
parting agent
nebuliser on the
Robacta TC
1000
NOTE!
If the parting agent nebuliser is positioned too high, there is a risk of parting
agent leaking out around the spray holes in the cleaning opening.
Position the parting agent nebuliser below the upper edge of the housing.
NOTE!
Ensure that the length of the parting agent hose between the device and the
parting agent nebuliser does not exceed 1 m (40 in.).
1
Bolt the parting agent nebuliser to a level, firm and vibration-free surface.
The installer is responsible for selecting the right type of fixing.
2
NOTE!
Use the parting agent hoses supplied
with the parting agent nebuliser to
connect the nebuliser to the cleaning
device.
52
To Next Page
Loading...