Fronius Robacta TC 1000 - Fill-Level Sensor Setup and Calibration

Fitting and using the fill-level control sensor
General
NOTE!
The fill-level control sensor can only be used in conjunction with parting agent
nebuliser V.
Controls and in-
dicators on the
sensor
(1)
(2)
(3)
(1) 'OUT OFF' button
for programming the sensor
(2) 'OUT ON' button
for programming the sensor
(3) LED
indicates the sensor operating
status
-
LED on/flashing: sensor is
active
-
LED on/not flashing: sensor
is not active
Installation ad-
apter borehole
dimensions
57
15 3,2
4,2
28
36
13
24
3,2
mm
2.24
0.59 0.13
0.17
1.10
1.42
0.51
0.94
0.13
inch
59
EN