Fronius Robacta TC 1000 - Wire Cutter Installation Process

Installing the wire cutter
Installing the
wire cutter on
the Robacta TC
1000
(1)
(2)
(3)
2 x
1
Attach the wire cutter holder (1) to
the cleaning device
2
Fix the wire cutter (2) to the holder
(1) using the two screws, two wash-
ers, two lock washers and two nuts
as shown. The installer is respons-
ible for selecting the correct
screws, washers, lock washers and
nuts
3
Attach the protective cover (3) to
the holder (1)
4
If using an electrically controlled
wire cutter: Plug the wire cutter
connecting cable into the wire cut-
ter connection socket on the
cleaning device
NOTE!
The wire cutter cannot be supplied with compressed air from the cleaning
device.
The wire cutter must be supplied with compressed air from a separate supply
line.
Fitting the wire
cutter to clean-
ing unit S
(1)
(2)
1
Using 2 screws and 2 lock washers,
screw the wire cutter (1) onto the
cleaning unit (2) fastening nuts.
The installer is responsible for se-
lecting the right screws and lock
washers
2
If using an electrically-controlled
wire cutter: Plug the wire cutter
connecting cable into the wire cut-
ter connection socket on the
cleaning unit
NOTE!
The wire cutter cannot be supplied with compressed air from the cleaning unit.
The wire cutter must be supplied with compressed air from a separate supply
line.
48