Error is sent to the robot. Overtemperature and fill level indicators flash at the
same time, no cleaning takes place
Quick Stop is active (HI - Quick Stop = LO / LO - Quick Stop =HI)
Deactivate Quick Stop (HI - Quick Stop = HI / LO - Quick Stop =LO)
Fault in the cleaning device
Disconnect the cleaning device from the mains and wait for approx. 1
minute before reconnecting it to the mains
Contact After-Sales Service if this does not remedy the situation
Cause:
Remedy:
Cause:
Remedy:
77
EN
To Next Page
Loading...