Menu items in the Set-up menu
Standby Manual activation / deactivation of Standby mode
- No energy is fed into the grid.
- The Startup LED will show steady orange.
- In the display, STANDBY / ENTER are alternately displayed
- In Standby mode, no other menu item at menu level can be accessed or adjusted.
- The automatic switchover into the "NOW" display mode after 2 minutes of keyboard
inactivity does not occur.
- Standby mode can only be terminated manually by pressing the "Enter" key.
- Pressing "Enter" at any time will cause energy to resume feeding into the grid, as
long as there is no error (state code)
Switching off Standby mode (manually switching off feeding energy into the grid):
1
Select the "Standby" item
2
Press "Enter" function key
"STANDBY" and "ENTER" appear alternately on the display.
Standby mode is now active.
The Startup LED shows steady orange.
Resuming feeding energy into the grid:
"STANDBY" and "ENTER" appear alternately on the display when in Standby mode.
1
Press the "Enter" function key to resume feeding energy into the grid
The "Standby" menu item is displayed.
At the same time, the inverter enters the startup phase.
The operating state LED shows steady green when feeding energy into the grid has
been resumed.
WiFi Access
Point
Activating / deactivating the WiFi Access Point. This is necessary for setting up or adjust-
ing system monitoring using the Datamanager web interface, for example. If no
Datamanager is detected by the inverter, [not available] is displayed
Setting range WiFi Access Point
[stopped]
Activate WiFi AP?
To activate the WiFi Access Point Press the "Enter" key
WiFi Access Point
[active]
The SS-ID (SS) and password (PW) are displayed.
Deactivate WiFi AP?
To deactivate the WiFi Access Point Press the "Enter"
key
51
EN
To Next Page
Loading...
Need help?
General