Setting range German, English, French, Dutch, Italian, Spanish, Czech,
Slovak, etc.
Contrast
Set the contrast on the display
Setting range 0 - 10
Factory setting 5
Since the contrast is temperature-dependent, it may be necessary to adjust the setting
under the "Contrast" menu item when the environmental conditions change.
Illumination
Initial setting for display illumination
The "Illumination" menu item only relates to the display backlighting.
Setting range AUTO / ON / OFF
Factory setting AUTO
AUTO: The display backlighting is activated by pressing any key. If no key is
pressed for 2 minutes, the display backlighting will go off again.
ON: The display backlighting remains permanently on when the inverter is act-
ive.
OFF: The display backlighting is permanently switched off.
ENERGY YIELD The following settings can be changed/set here:
- Counter deviation / Calibration
- Currency
- Feed-in tariff
- CO2 factor
Setting range Currency / Feed-in tariff
Counter deviation / calibration
Calibrating the counter
Currency
Set the currency
Setting range 3 characters, A-Z
Feed-in tariff
Set the remuneration rate for energy fed into the grid
Setting range 2 digits, 3 decimal places
Factory setting (depends on country setup)
55
EN
To Next Page
Loading...
