SETUP menu item
Initial setting The inverter is pre-configured after commissioning has been completely carried out (e.g.
using the Installation Wizard) according to the country setup.
The SETUP menu item allows the initial settings of the inverter to be changed easily to
bring it in line, as closely as possible, with the preferences and requirements of the user.
Software updates IMPORTANT! As a result of software updates, you may find that your device has certain
functions that are not described in these Operating Instructions, or vice versa. Certain
illustrations may also differ slightly from the actual controls on your device, but these
controls function in exactly the same way.
Navigating the
SETUP menu
item
Entering the SETUP menu item
1
At the menu level, use the “Left” or
“Right” keys to select the “SETUP”
menu item
2
Press the "Enter" key
The first entry under the SETUP menu
item is displayed:
"Standby"
Scrolling between the entries
3
Use the "Up" and "Down" keys to
move between the available
entries
Exiting an entry
4
To exit a menu entry, press the
"Back" key
The menu level appears
If no key is pressed for 2 minutes:
57
EN
To Next Page
Loading...
