INF-TN1FSC-E 133
(4) Installation of detector
(1) Wrap the belt around the pipe.
FSDP2, FSDP1
Adjusts the length of the wire rope according to the
piping size, fi xes the wire on the pipe.
FSDP0
(2) Fully screw up to the right side.
Screw
(3) Before mounting the sensor to the pipe, apply grease evenly over the sensor unit and the ab-
sorber unit that are to contact the pipe.
Absorber unit
Sensor unit
Grease
(4) Fasten the sensor with the belt checking the fl ow direction.
FSDP2, FSDP1
Flow
direction
Flow
direction
FSDP0
To Next Page
Loading...
