Fuji Electric FLD-1 - 10.1.3 UNIT OF OUTPUT: when changing unit of each output

INF-TN1FSC-E 67
10.1.3 UNIT OF OUTPUT: when changing unit of each output
Flow rate unit: Select the unit of fl ow rate and output range.
Metric system:
L/s, L/min, L/h, L/d, kL/d, ML/d, m
3
/s, m
3
/min, m
3
/h, m
3
/d, km
3
/d, Mm
3
/d, BBL/s, BBL/min,
BBL/h, BBL/d, kBBL/d, MBBL/d
English system: gal/s, gal/min, gal/h, gal/d, kgal/d, Mgal/d, ft
3
/s, ft
3
/min, ft
3
/h, ft
3
/d, kft
3
/d, Mft
3
/d, BBL/s,
BBL/min, BBL/h, BBL/d, kBBL/d, MBBL/d
Flow rate total: Select the unit of fl ow rate.
Metric system:
mL, L, m
3
, km
3
, Mm
3
, mBBL, BBL, kBBL
English system: gal, kgal, ft
3
, kft
3
, Mft
3
, mBBL, BBL, kBBL, ACRE-ft
Temperature: Select the unit of temperature input.
Metric system: °C
, K
English system: F, K
Heat fl ow: Select the unit of heat fl ow and output range.
MJ/h, GJ/h, BTU/h, kBTU/h, MBTU/h
Thermal total: Select the unit of total thermal.
MJ, GJ, BTU, kBTU, MBTU
Note) For the change of SYSTEM UNIT, refer to “10.3.1(2) SYSTEM UNIT”.
Direction of selected unit
Display Logger Printer
Flow rate unit
{{{: The unit selected by the unit of output is used.
Flow rate total
{{{: The unit selected by measurement screen is used.
Temperature
{{{
Heat fl ow
{{{
Thermal total
{{{
[Operation]
(1) Press the
or key on the SITE SETUP page and
select “UNIT OF OUTPUT”. Then, press the
ENT
key.
This function enables you to set unit of fl ow rate, total, temperature and total heat quantity.