Fuji Electric FLD-1 - 8.3 Use of surface-treated accessories

INF-TN1FSC-E 43
8.3 Use of surface-treated accessories
Eliminate pitting, corrosion, unevenness, etc. with paint thinner and sandpaper from the pipe
portion where the detector is to be mounted.
Note) In case jute is wound on a pipe, it should be peeled off before the above treatment.
When cast iron pipe is used, grind the sensor mounting surface by using a sander for
smoothness.
Jute is wound
Detector Width
Pipe
Width
Small outer
diameter FLD22
320 mm or more
Small size
(standard) sensor
FLD12
540 mm or more
Large size sensor
FLD51
Medium size sensor
FLD51
Mounting dimension
(L) + 200 mm or more
Mounting dimension
(L) + 200 mm or more
High temperature
FLD32
530 mm or more