12 INF-TN1FSC-E
4.3.3 Insertion and removal
Methods for insertion and removal of an SD memory card are described below.
(1) Insertion
Step 1) Open the cap from the main unit bottom
face.
SD memory card slot
Cap
Step 2) Insert a memory card into the memory
card slot in the main unit bottom face in
the direction shown on the right.
Card push-in system is adopted for card
mounting. Positively push in the memory
card to the lock-up position.
When inserting, align the memory card body to match the slot.
Do not insert the card at an angle. Card should slide into slot freely without force. If the
memory card is pushed with force in the state where the card is inserted as tilted, the con-
nector in the main unit will be broken. Be careful.
CAUTION
(2) Removal
Card push-in system is adopted for card mounting. Push the card in straight. The card is un-
locked and can be removed.
The data stored on a memory card can be directly read with a PC.
• Do not remove the memory card during data write operation.
• Do not remove the memory card before the main unit identifi es the inserted memory card
after its insertion.
• Be careful with static electricity at the time of removal of the memory card.
CAUTION
To Next Page
Loading...
