Fuji Electric FLD-1 - 10.1.5 TOTALIZER: when performing the total process of measured data (totalize)

INF-TN1FSC-E 73
10.1.5 TOTALIZER: when performing the total process of measured data
(totalize)
(1) To start/set total output
[Operation]
(1) Select “TOTALIZER” on the SITE SETUP screen by
pressing the
or key.
Press the
ENT
key to display the total output selection
screen.
Total process and setting of total output can be performed.
(3) Move the cursor to “START” by the
or key,
and then press the
ENT
key.
The total will start.
(2) Pressing the
ENT
key enables you to select the total
output mode.
Select the mode from MANUAL, FIXED TIME, and
TIMER by pressing the
or key.
(For details of MODE, refer to description of the
mode in the following page.)
(4) To stop the total output in the middle, move the cur-
sor to “STOP” and press the
ENT
key.
“STOP” is also possible from the totalizing calcula-
tion display button on the measurement screen.
Total will not start unless the cursor is pointed to “START”
and the
ENT
key is pressed.
Even if the timer setting is performed after scheduled Start
date may pass than the time of the main unit, total will not
be carried out.
CAUTION