52 INF-TN1FSC-E
(6) Make sure that the center mark on the sensor is
aligned with the marking line. Then, connect the
coaxial cable to the transmitter.
Note) Do not pull the coaxial cable.
If it is pulled, the sensor is shifted which
results in incorrect measurements.
(7) After mounting the upstream sensor, mount the
downstream sensor in the same way.
The fi gure is for mounting by the Z method.
Upstream
side
Cable side
Cable sideTransmitting marker side
Transmitting marker side
Downstream
side
Marking line
Matching mark
To Next Page
Loading...
