EasyManua.ls Logo

Fuji Xerox ApeosPort-VI C3370 - Page 616

Fuji Xerox ApeosPort-VI C3370
889 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Problem Solving
616
Problem Solving
15
"027-001" - "032-999"
026-729
[Cause] Probable causes are as follows:
1) An error occurred during WSD communications.
2) Application other than [Windows Fax and Scan] was used to
scan a document on the scanner (WSD).
[Remedy] For 1), check whether the network cable is correctly connected
or check the amount of available memory of the destination
device.
For 2), Use [Windows Fax and Scan] to scan. If using another
application, set the document on the document glass.
Note
z
WSD stands for Web Services on Devices.
026-730
[Cause] The size of paper loaded in the specified tray is unknown.
[Remedy] Check whether the paper guides are correctly positioned in the
tray, and then try again.
026-736
[Cause] An internal error occurred while sending the scanned document
to the HTTP server.
[Remedy] Execute the operation again. If the error still is not resolved,
contact our Customer Support Center.
026-737
[Cause] Unable to send the scanned document to the HTTP server
because a network error occurred.
[Remedy] Consult your network administrator whether the network or the
server have any problem.
026-738
[Cause] The machine failed to send scanned document data to the
HTTP server because Web application is closed during it.
[Remedy] Execute the operation again.
026-739
[Cause] When authentication succeeds, all jobs are canceled because
there is a pending job.
[Remedy] No measure is required.
Error Code
Cause and Remedy
027-442
[Cause] The IP address of IPv6 already exists.
[Remedy] Change the [Auto Stateless Address 1] for IPv6 on the machine,
or the IP address of IPv6 on the network device, to remove the
duplication of addresses.
027-443
[Cause] The IP address of IPv6 already exists.
[Remedy] Change the [Auto Stateless Address 2] for IPv6 on the machine,
or the IP address of IPv6 on the network device, to remove the
duplication of addresses.
027-444
[Cause] The IP address of IPv6 already exists.
[Remedy] Change the [Auto Stateless Address 3] for IPv6 on the machine,
or the IP address of IPv6 on the network device, to remove the
duplication of addresses.
027-445
[Cause] IP address for IPv6 set manually is incorrect.
[Remedy] Set the IP address correctly.
Error Code
Cause and Remedy

Table of Contents

Other manuals for Fuji Xerox ApeosPort-VI C3370

Related product manuals