Fuji Xerox DocuCentre-IV 2060 Administrator's Guide

Installation Procedures
295
Using IP Fax (SIP)
10
Installation Procedures
This section describes the configuration procedures to use the IP Fax (SIP) feature on
the machine.
The following shows the reference section for each procedure.
Step 1 Enabling Port and Setting up TCP/IP............................................................................ 295
Step 2 Configuring the SIP User Name ................................................................................... 296
Step 3 Configuring Fax Environment ...................................................................................... 296
Step 4 Configuring the SIP Server ........................................................................................... 297
Step 5 Registering the VoIP Gateway...................................................................................... 298
Step 1 Enabling Port and Setting up TCP/IP
To use the IP Fax (SIP) feature on the machine, enable the port and set the IP
addresses. The following shows the configuration procedures on the machine.
You can configure the settings using CentreWare Internet Services. For information on how to use
CentreWare Internet Services, refer to "Configuring Machine Settings Using CentreWare Internet
Services" (P.243).
1 Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator’s user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator’s
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home] screen.
2 Enable the SIP port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [SIP], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close] repeatedly until the [Tools] screen is displayed.
3 Set an IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for
obtaining the address. If an IP address cannot be obtained automatically, or if manual
configuration is preferred, confirm the settings of an IP address, a subnet mask, and a
gateway address.
For information on how to set an IP address, refer to "Protocol Settings" (P.149).
4 Select [Close] repeatedly until the [Tools] screen is displayed.
5 Select [Close].
Note • Rebooting the machine may be required depending on the settings. When a message
displayed on the screen, follow the message and reboot the machine.
Downloaded From ManualsPrinter.com Manuals

Fuji Xerox DocuCentre-IV 2060 Specifications

General

Brand	Fuji Xerox
Model	DocuCentre-IV 2060
Category	All in One Printer
Language	English