Notes and Restrictions
575
Appendix
16
îš„ID Card Copy
z
The machine does not shift the ID card image to the center of the output in any
magnification ratio and image size you specified.
z
When the reduced size is specified to copy an ID card, the machine may copy the ID
card in a different orientation from the original orientation depending on the
magnification ratio specified.
Notes and Restrictions on the Use of the Print Feature
îš„Output of Long Feed Documents
The output of long feed documents is not supported.
îš„PostScript Driver
Some options such as Poster (Photo Enlargement) are not supported by the PostScript
driver. With the Pages Per Sheet (N-Up) feature, you can specify 2, 4, 6, 9, or 16 pages
up, and with or without frame borders.
îš„Printing from Macintosh via USB Connection
When you send a print job from the PostScript driver of Macintosh connected via USB
and the job includes application data with graphic data (EPS file including binary data)
pasted, the machine may misidentify the binary data as protocol data; therefore, the
output of text data may extend for multiple pages.
In this case, select [RAW] for [Adobe Communication Protocol] under [Tools] >
[Connectivity & Network Setup] > [Port Settings] > [USB] to properly print data which
includes EPS files with binary data.
îš„Gigabit Ethernet Kit (Optional)
Enabling the Gigabit Ethernet Kit achieves high-network communication speed, but it
does not shorten the entire printing time.
îš„Print Jobs while the Control Panel is being Operated
The processing and output speeds of print jobs may slow in the following conditions:
z
The control panel is being operated while the machine processes a print job.
z
The status of a print job is being viewed in the [Job Status] screen.
îš„When the Print Results Differ from the Settings
As in the following cases, insufficient memory for the print page buffer may cause print
result in not printing as specified. In this case, we recommend that you increase the
memory.
z
Printed only on 1 side when 2 sided printing is specified.
z
A job was terminated (If data cannot be written to the print page buffer, the job
including that page is terminated).
îš„Direct Print via USB Host (a USB memory device)
When the machine is in the Sleep mode, your computer does not detect the machine
if you connect a USB memory device or the Memory Card Reader to the machine. Exit
the Sleep mode, and then connect the USB memory device or the Memory Card
Reader and send a print job.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
