15 Problem Solving
504
Problem Solving
15
Stapler Faults
This section describes how to clear stapler troubles when the optional finisher is
installed.
Perform the procedures on the following pages when copies are not stapled or staples
are bent. Contact our Customer Support Center if the problem persists after you have
tried the following solutions.
If copies are stapled as shown in the figures below, contact our Customer Support
Center.
One side of staple rising up
Staple bent in reverse direction
Staple rising up with
center pressed in
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
