3 Maintenance
64
Maintenance
3
3 Hold the tabs on both sides of a new staple
cartridge, and insert it into the original posi-
tion until it clicks.
4 Repeat steps 2 and 3 to replace the other
staple cartridge.
5 Close the side cover of the booklet maker unit for Finisher-B1.
Note • If the cover is not completely closed, a message will appear and the machine remain
paused.
Emptying Punch Waste Container (for Finisher-B1)
When the optional Finisher-B1 is installed and the hole punch waste container
becomes full, a message appears on the touch screen. When the message appears,
empty the hole punch waste container as instructed.
Make sure to discard all paper chads when emptying the hole punch waste container.
Not doing so will cause the container to fill up before the message telling you to empty
the container appears again, and this can cause machine malfunction.
Important • Empty the hole punch waste container when the machine is on. If you empty the container
while the machine is off, the machine does not recognize that the container has been
emptied.
1 Make sure that the machine is not operating,
lift the top transport cover, and then open the
front transport cover of the finisher.
2 Pull out the hole punch waste container.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
