3 Maintenance
60
Maintenance
3
8 Pull out the cartridge tape straight toward
you and horizontally without tearing.
Important • Be sure to pull the tape out straight and
horizontally. If the tape is pulled out
obliquely, it may tear before it is
completely out of the cartridge.
9 Push the drum cartridge again so that it is
correctly placed.
10 Close the Cover A tightly.
11 Close the Tray 5 (bypass).
12 Close the front cover.
Note • A message will be displayed and the machine will not operate if the front cover is not
completely closed.
Replacing Staple Cartridge (for Finisher-A1)
When the optional Finisher-A1 is installed and the staple cartridge needs to be
replaced, a message appears on the touch screen. When this message appears, load
a new staple case into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and
performance. Use only staple cartridges recommended by Fuji Xerox.
Note • To order a staple cartridge, contact our Customer Support Center.
1 Make sure that the machine is not operating,
and open the finisher front cover.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
