HP-GL2 Emulation
559
Appendix
16
Print control 150
(HP-GL
mode)
Selects a graphics language. This setting affects to IW, OW, and UC of
HP-GL/2 commands.
[0] (Default) : HP-GL
[1] : HP-GL/2
Note • To print HP-GL/2 command that does not include BP command,
select [HP-GL/2].
151
(Hard clip)
Sets the size of hard clip area.
In HP-GL mode, the plottable area is determined in line with the paper
size, apart from the printable area. This area is called the "hard clip area",
and determines the maximum range of pen movement. Accordingly,
images cannot be drawn outside the boundary of the hard clip area.
[0] : Standard
[2] (Default) : Paper
For more information on hard clip area, refer to "Hard Clip Area" (P.563).
152 (Eject
command
SP)
Sets the command that indicates the end of plotting. When the command
specified here is received, plotting is terminated and the paper is output.
[0] (Default) : OFF
[1] : ON
The default value is [ON] for SPO, and [OFF] for the others.
Note • If multiple commands are specified, when one of the commands is
received, plotting is terminated and the paper is output.
153 (Eject
command
SPO)
154 (Eject
command
NR)
155 (Eject
command
FR)
156 (Eject
command
PG)
157 (Eject
command AF)
158 (Eject
command
AH)
Parameter Item No. Value
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
