EasyManuals Logo

Fuji Xerox DocuCentre-IV 2060 Administrator's Guide

Fuji Xerox DocuCentre-IV 2060
633 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #588 background imageLoading...
Page #588 background image
16 Appendix
586
Appendix
16
Notes on E-mail Receptions
A large volume of e-mail may not be printed if the memory capacity is insufficient. In
this case, increase the memory size or ask the sender to lower the resolution.
Notes on E-mail Reception when [Split by Data Size] is specified
When [Split by Data Size] is specified as the e-mail splitting method, even if you receive
the split e-mail, you cannot reconstruct and print it.
Notes on E-mail Transmission when [Split by Data Size] is specified
When [Split by Data Size] is specified as the e-mail splitting method, split the data so
as to enable e-mail reception with e-mail software corresponding to the Message/
Partial content type.
Job Counter Report
If you specify multiple different [Pages per Side] settings using the Build Job feature,
the numbers of pages displayed for [2 Pages Up] and [Greater than 2 Pages Up]
displayed on the Job Counter Report are calculated according to the latest N-up setting
you specify.
Example 1:
When you select [2 Pages Up] for Document 1 (4 pages) and [Off] for Document 2 (2
pages), both Documents 1 and 2 are set to [Off] and the number of printed pages is
calculated as follows:
z
Total pages: 4
z
2 up: 0
Example 2:
When you select [Off] for Document 1 (4 pages) and [2 Pages Up] for Document 2 (2
pages), both Documents 1 and 2 are set to [2 Pages Up] and the number of printed
pages is calculated as follows:
z
Total pages: 5
z
2 up: 5
On ApeosWare Log Management or ApeosWare Accounting Service, the numbers of
pages for 2in1, 4in1, and 8in1 are also calculated in the same way as described above.
The meter on the [Billing Information] screen calculates the number of printed pages
correctly regardless of the [Pages per Side] setting.
Folder Passcode
z
You do not need to specify the passcode of a recipient when sending an IP Fax (SIP)
to a remote folder. Thus, the passcode enclosed in "\" or "/" is not replaced by "*" as
with that of regular faxes. If you select an IP Fax (SIP) by mistake and specify the
passcode of a recipient when you send a fax or an Internet fax, the passcode is
displayed on the touch panel screen, the Job Status screen, and a report. Be sure to
check the type of fax before sending a fax to a remote folder.
z
Communications and Information network Association of Japan (CIAJ) confirms the
use of image-/tiff-fx.
Downloaded From ManualsPrinter.com Manuals

Table of Contents

Other manuals for Fuji Xerox DocuCentre-IV 2060

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fuji Xerox DocuCentre-IV 2060 and is the answer not in the manual?

Fuji Xerox DocuCentre-IV 2060 Specifications

General IconGeneral
BrandFuji Xerox
ModelDocuCentre-IV 2060
CategoryAll in One Printer
LanguageEnglish

Related product manuals