4 Machine Status
90
Machine Status
4
2 Select the memory number to use.
îš„Factory Defaults
You can use the factory default settings.
îš„Custom Settings
Displays the numbers stored in the memory.
Programming
You can check or change the value set for the print mode item number.
For the item numbers that can be configured in each mode menu, refer to "ESC/P-K Emulation Settings"
(P.530), "PDF Direct Print Settings" (P.543), "PCL Emulation Settings" (P.549), and "HP-GL/2
Emulation Settings" (P.556).
1 Select [Programming].
2 Enter the item number of the feature to set in
[Item Number] with the numeric keypad.
3 Select [Confirm]. The current setting value
appears.
4 Select [Change Value].
5 Enter [New Value] with the numeric keypad.
6 Select [Save].
Store/Delete Programming
For ESC/P-K and HP-GL/2 emulations, you can register settings in memory.
You can register up to 20 print modes for ESC/P-K and HP-GL/2 emulations.
1 Select [Store/Delete Programming].
2 Select [Store Current Selections] or [Delete].
îš„Store Current Selections
Stores the current selections. If you select a
number already used, its settings will be
overwritten with the new settings. The
overwritten settings cannot be restored.
îš„Delete
Deletes a number selected. Select [Delete], and then select a number to delete.
Important • Deleted numbers cannot be restored.
3 Select the memory number to store or to delete.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
