Fuji Xerox DocuCentre-V C2263

Maintenance
104
Maintenance
3
1 Select [Calibration] on the Services Home screen.
If [Calibration] is not displayed, follow the procedure below.
1) Press the <Log In/Out> button.
2) Enter the system administrator’s user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator’s passcode,
and select [Enter].
Note
z
The default user ID is "11111".
z
The default passcode is "x-admin".
3) Select [Tools] on the Services Home screen.
Note
z
When the Services Home screen is not displayed on the touch screen, press the <Services Home> button.
4) Select [System Settings] > [Common Service Settings] > [Image Quality Adjustment].
2 Press the <Log In/Out> button.
Note
z
You also can select [Calibration] on the Services Home screen. Selecting [Calibration] on the Services Home
screen shows the screen in step 6.
123
456
789
0
＃
C