Fuji Xerox DocuCentre-V C2263 Administrator's Guide

Executing Calibration
105
Maintenance
3
3 Select [System Settings] > [Common Service Settings] > [Image Quality Adjustment].
4 Select [Calibration].
5 Set [Screen Type], [Paper Supply], and [Target].
Note
z
For Target, select from [Copy & Print Jobs], [Copy Jobs Only], [Print Jobs Only], and [None]. When [Copy &
Print] is not selected for [Target], calibration is not valid for the mode not listed in [Target].
6 Select [Start].
Note
z
The message "Outputting the Calibration Chart... - Copy Job" appears and the document for calibration
(Calibration Chart) is printed.
7 Align the magenta patch (squares printed at the top and bottom of the Calibration Chart)
of the printed Calibration Chart against the left side of the document glass, and load the
chart facing down on the document glass.
Note
z
Place the Calibration Chart on the document glass.

Fuji Xerox DocuCentre-V C2263 Specifications

General

Print Resolution	1200 x 2400 dpi
Scan Resolution	600 x 600 dpi
Functions	Print, Copy, Scan, Fax
Memory (Standard)	1GB
Duplex Printing	Yes
Fax Transmission Speed	33.6 kbps
Supported Operating Systems	Windows, Mac OS, Linux
Connectivity	USB 2.0, Ethernet
Paper Size	A4, A5, B5
Hard Disk Drive	160 GB