EasyManuals Logo

Fuji Xerox DocuCentre-V C2263 Administrator's Guide

Fuji Xerox DocuCentre-V C2263
771 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #604 background imageLoading...
Page #604 background image
Problem Solving
604
Problem Solving
15
117-311
[Cause] Data Security Kit is not attached correctly.
[Remedy] Insert Data Security Kit into the correct slot.
117-312
[Cause] An error occurred in the machine.
[Remedy] Contact our Customer Support Center.
117-319
117-320
117-321
117-322
117-323
117-324
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen
is blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
117-326
117-327
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen
is blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
117-329
117-331
117-332
117-333
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen
is blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
117-343
[Cause] Probable causes are follows.
1) When [Image Log Control] on Tools is invaled and [Enabled]
is set for [Log Transfer] under [Transfer Image Log] , [Transfer
Per Job Basis] is set for [Logs to Transfer].
2) When [Transfer Image Log] is invalid (the hard disk is not
installed), [Log Transfer] is set to [Enabled].
[Remedy] For 1), set other than [Transfer Per Job Basis] for [Log to
Transfer].
For 2), install the hard disk to tha machine, or set [Pause] for
[Logs To Transfer].
117-345
[Cause] An error occurred between the machine and the device
connected.
[Remedy] Switch on the machine power without connecting the device for
EP system, and then set [Login Type] to any option other than
[Login to Remote Accounts] under [Tools] > [Authentication/
Security Settings] > [Authentication].
117-347
[Cause] The life of the component which cannot be replaced is expired.
The machine itself needs to be replaced.
[Remedy] Contact our Customer Support Center.
117-348
117-350
[Cause] The unformatted SD card used in the other machine is installed.
[Remedy] Switch off the machine power, make sure that the touch screen
is blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
Error Code
Cause and Remedy

Table of Contents

Other manuals for Fuji Xerox DocuCentre-V C2263

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fuji Xerox DocuCentre-V C2263 and is the answer not in the manual?

Fuji Xerox DocuCentre-V C2263 Specifications

General IconGeneral
Print Resolution1200 x 2400 dpi
Scan Resolution600 x 600 dpi
FunctionsPrint, Copy, Scan, Fax
Memory (Standard)1GB
Duplex PrintingYes
Fax Transmission Speed33.6 kbps
Supported Operating SystemsWindows, Mac OS, Linux
ConnectivityUSB 2.0, Ethernet
Paper SizeA4, A5, B5
Hard Disk Drive160 GB

Related product manuals