6.6 Error Messages and Error Codes 219
016-573 Could not print because the contents of the job ticket are not correct.
Make sure that the print driver on the computer to which the print job is sent is properly installed,
meets the operating conditions, or is the print driver for this printer.
016-598 The size of one-page worth of e-mail data after splitting exceeds the maximum message size
allowed.
Increase the value of under [Properties] > [Network Settings] > [Protocol Settings] > [SMTP] on
CentreWare Internet Services.
Refer to
• CentreWare Internet Services online help
016-700 The process was terminated because the Secure Print password set with the print driver has
fewer characters than the minimum number of password characters specified for the printer.
Set the print driver password so it has more characters that the minimum number of password
characters specified for the printer.
016-701 The print data of ART EX could not be processed due to insufficient memory. Try printing again by
lowering the resolution and not using two-sided printing or N up.
016-702 PCL or PostScript print data could not be processed because of insufficient print page buffer size.
Perform one of the following steps.
• If the [Image Quality] setting is [High Resolution], change it to [Standard] (PCL print driver) or
[High Speed] (PostScript print driver).
• On the [Advanced Settings] tab, change the [Print Page Mode] setting to [On]. (PCL only)
• Increase the size of the page print buffer.
• Install Extension System Memory (optional) to increase memory capacity.
Refer to
• [Image Quality]/[Print Page Mode]: Online help for the print driver
• Print page buffer: “[Allocate Memory]” (P. 184)
016-705 A Secure Print document could not be registered because the HDD Extension Kit (optional) is not
installed.
HDD Extension Kit (optional) must be installed in order to use Secure Print.
016-706 The maximum allowable number of security/sample set users has been exceeded.
Delete unneeded documents accumulated on the printer and Secure Print registered users,
before trying to print again.
016-707 A sample set could not be printed because the HDD Extension Kit (optional) is not installed, or
because there is some problem with the HDD Extension Kit (optional).
HDD Extension Kit (optional) must be installed in order to use the sample set function.
016-708 Printing is not possible because of insufficient the HDD Extension Kit (optional) space.
Delete unneeded data from the HDD Extension Kit (optional) to free up space.
016-709 An error occurred during ART EX processing.
Delete the print job and try printing again.
016-710 Delayed printing could not be performed because the HDD Extension Kit (optional) is not
installed, or because there is some problem with the HDD Extension Kit (optional).
HDD Extension Kit (optional) must be installed in order to use the delayed print function.
016-711 The specified e-mail size exceeds the maximum allowable value.
Reduce the data size of the attached file by lowering the resolution or magnification factor, or
divide the file into multiple parts.
016-716 A TIFF file could not be spooled because of insufficient the HDD Extension Kit (optional) capacity.
Delete unneeded data from the HDD Extension Kit (optional) to free up space.
016-718 PCL print data could not be processed because of insufficient memory.
Reduce the resolution and try printing again without 2-Sided printing and multiple-up.
016-719 PCL print data could not be processed because of insufficient print page buffer size.
Increase the size of the page print buffer.
016-720 A command that cannot be processed is included in the PCL print data.
Check the print data and try printing again.
Error Code Cause/Remedy
To Next Page
Loading...
Need help?
General
