Fuji Xerox DocuPrint 3105 User Manual

6.6 Error Messages and Error Codes 227
024-702 This message is displayed when [Delete Job] is set to [When Jam Occurs] on the printer.
A paper jam occurred during printing.
Clear the paper jam, and try printing again.
024-742 The number of prints of a job for which booklet printing is specified using the print options exceeds
the number of prints allowed for a booklet.
Use the print options to change the number of prints to that is allowed, or cancel booklet printing.
024-746 A function (paper size, paper tray, or duplex printing) has been specified that cannot be used in
combination with the specified paper quality.
Check the print data.
024-747 Print parameter combinations are incorrect. For example: specifying a custom size and specifying
[Auto Paper Select] for [Paper Tray]. Check the print data.
024-775 The number of prints of a job for which booklet is specified with print options exceeds the number
of booklets that can be printed.
Use print options to divide the job so the number of prints is within the allowable range for booklet
or cancel booklets.
025-596
025-597
An error occurred in the HDD Extension Kit (optional).
Replace the HDD Extension Kit (optional).
026-400 More than two devices are connected to the USB port.
Only up to two devices are allowed to be connected to the USB port, so disconnect extra devices.
If this does not resolve the problem, switch the power off, and then switch it back on after the
control panel display has gone dark.
026-704 The DocuWorks file contains features that are not supported by the printer, and therefore the file
could not be printed.
Open the DocuWorks file using DocuWorks or DocuWorks Viewer, and print the file from [Print]
under the [File] menu using the print driver.
026-705 DocuWorks file could not be printed using ContentsBridge Utility due to insuffucient memory.
Resolve this by one of the following methods.Change the [Image quality] setting in the [Image
Option] dialog box of ContentsBridge Utility as follows:
• Check the [Image quality] setting in the [Image Option] dialog box of ContentsBridge Utility, and
change it to [Standard] if [High Resolution] is selected, or to [Fineness] if [Generation
(Standard)] is selected.
• Install additional system memory (optional) to add on memory.
• Open the DocuWorks file using DocuWorks or DocuWorks Viewer, and print the file from [Print]
under the [File] menu using the print driver.
026-706 The DocuWorks file could not be printed because it is prohibited from printing.
Clear the DocuWorks file’s print prohibition using DocuWorks, and try printing again.
Refer to
• Manual provided with DocuWorks
026-707 The password of the DocuWorks file does not match the password set on the printer or
ContentsBridgeUtility.
Set the correct password on the printer or ContentsBridgeUtility, and try printing again.
Note
• If printing the DocuWorks file without using ContentsBridge Utility, see “ [XDW (DocuWorks)]”
(P. 129) to change the [XDW (DocuWorks)] setting on the control panel.
026-718 The combination of print features (document size, paper size, paper tray, 2-sided printing, output
tray) you specified is not allowed.
Check the print data, and try printing again.
026-724
026-725
An error occurred communicating with the EP server.
Switch the power off and back on again.
If this does not resolve the problem, contact our Customer Support Center or your dealer.
Error Code Cause/Remedy

Fuji Xerox DocuPrint 3105 Specifications

General

Brand	Fuji Xerox
Model	DocuPrint 3105
Category	Printer
Language	English