Troubleshooting 196
SSF Misfeed Jam
Problem Action
Print media misfeeds occur in the
SSF.
Ensure that the SSF is properly inserted.
If the problem persists, verify that the correct print media is being
used.
Verify that the correct print media is being used.
See also:
• "Usable Print Media" on page 100
If not, use the print media recommended for the printer.
If the problem persists, ensure that the print media is not damp.
Ensure that the print media is not curled.
If the problem persists, fan the print media.
Ensure that the print media is not damp.
If the print media is damp, turn over the print media.
If the problem persists, use print media that is not damp.
If the print media is not damp, fan the print media.
Fan the print media.
If the problem persists, wipe the feed roller in the SSF with a cloth
moistened with water.
Wipe the feed roller in the SSF with a cloth moistened with water.
If the problem persists, replace the drum cartridge if you have a spare
cartridge.
Replace the drum cartridge if you have a spare cartridge.
If the problem persists, contact the Fuji Xerox local representative
office or an authorised dealer.