Network Basics 58
Overview of Network Setup and Configuration
To set up and configure the network:
1 Connect the printer to the network using the recommended hardware and cables.
2 Turn on the printer and the computer.
3 Print the Printer Settings page and keep it for referencing network settings.
4 Install the driver software on the computer from the Driver CD Kit or PostScript Driver Library CD.
For information on driver installation, see the section in this chapter for the specific operating
system you are using.
5 Configure the printer’s TCP/IP address, which is required to identify the printer on the network.
• Microsoft
®
Windows
®
operating systems: Run the Installer on the Driver CD Kit or PostScript
Driver Library CD to automatically set the printer’s IP address if the printer is connected to an
established TCP/IP network. You can also manually set the printer’s IP address on the
operator panel.
• Mac OS
®
X and Linux systems: Manually set the printer’s TCP/IP address on the operator
panel.
6 Print a Printer Settings page to verify the new settings.
NOTE:
• If the Driver CD Kit or PostScript Driver Library CD is not available, you can download the latest driver from
the Fuji Xerox Web Site: http://www.fujixeroxprinters.com/
See also:
• "Printing a Printer Settings Page" on page 136
To Next Page
Loading...
Need help?
General
