System expansio ns
Removing and attaching the bott
om casing cover
You need to remove the top casing cover if you want to remove or install the following components:
• Memory modules
Remove the casing bottom cover
► Turnthedeviceover.
► If you are using a lathing clip and a padlock to pro tect the device, remove the lock
and open the latching clip (see "
Using a locking sl ide", Page 53).
or
► If you are using a latching clip and a Kensington Lock cable to protect the device,
remove the Kensington Lock cable and open the latching clip (see "
Using the
security lock", Page 52 and "Using a locking slide", Page 53).
3
2
1
► Push the release button on the rear side of the device in the direction of the arrow (1) while
at the same time sliding the bottom casing cover in the direction of the arrow (2).
► Lift the bottom casing cover off the device (3).
Fujitsu 97
To Next Page
Loading...
