Operation
Indicators on the device
The indicat ors are on the front of the c asin g. Which indicators are available on your
device depends on the configuration level you have selected.
Example: Device variant with SmartCard reader and/or palm sensor
321
No. indicat or Description
1
SmartCard read
er
indicator (dev
ice
dependent)
The indicator l
ights up when the device’s SmartCard reader is
accessed (devi
ce dependent).
2 Hard d isk indi
cator
The indicator
lights up when the hard disk drive in the device
is being acce
ssed.
3 P ower indic
ator
Attention:
In the energy saving mode, the device must not be
disconnect
ed from the mains, as this c an result in data loss.
• Indicator
is illuminated:
The device is switched on.
• Indicato
r flashes:
The device is in energy-saving mode. After being switched on
with the On/Off switch, the device powers up or returns to the
state it was in before it entered energy-saving mode.
• The indi
cator is not illuminated:
The device is s witched off (disconnected from the mains) or
is ready. If the device is ready it can be switched on with the
On/Off switch.
In the energy saving mode, the device must not be disconnected from
the mains, as this can result in data loss.
Fujitsu 41
To Next Page
Loading...
