Getting started
Fitting the device to the VESA interface on a monitor (optional)
With ESPRIMO Q 956/95 7 type devices, the casing cover is already fi tted
with the corresponding screw holes by default.
With ESPR IMO Q55x/Q958 type devices, you can order the corresponding
casing cover with screw holes separately if necessary.
The device must be fitted onto the screen in such a way that the connecting
and operating elements can be used from the side.
Remove the bottom c over
• Requirement: The casing is opened an d the casing cover is removed (refer to
"
Remove the casing bottom cove r", Pag e 97).
1
1
2
► Release the locking lug (1) on the underside cover from the casing cover
and remove the underside cover (2).
Information about fixing the underside cover is provided in Section "
Fitting the
underside cover (device-dependent) " , Page 18.
26 Fujitsu
To Next Page
Loading...
