Important notes
Important notes
ImportantnotesNotes
In this chapter you will find information regarding safety which it is essential to
take note of when working with your device.
Safety notes
SafetynotesNote
Please follow the safety
notes provided in the "Safety/Regulations" man ual
as well as the safety note
s given below.
When installing and ope
rating the device, please observe the notes on
ambient conditions in C
hapter "
Technical data", Page 101 and Chapter "Getting
started", Page 17 or the no
tes in the data sheets.
When setting up the dev
ice, make sure there is clearance all around it so that
thecasingreceives
enough ventilation. In order to avoid overheating, do not
cover the v enti lati
on areas on the m onitor or the device.
You should operate
the device only if the rated voltage of the device
is the same as the lo
cal mains voltage.
For complete disco
nnection from the mains voltage, you must pull
the mains plug out
of the socket.
Please note that c
omponents in the system as well as the surface
of the device ma
y become very h ot.
The activities
described in these instructions must always be performed w ith special care.
Only qualified
technicians should repair the device. Incorrect repairs could put the user
at great risk o
r cause serious damage to the equipment (electric shock, risk of fire).
Do not lay or p
lace any objects on the upper side of the device.
Do not apply a
ny pressure to the upper side of the device during operation.
Transport
ing the device
DeviceTr anspo r
tation
Re-trans
portation
Transport all devices separately in their original packaging or in a packaging
that protects them from knocks and jolts.
Unpack them only at the installation site.
If the device is brought from a c old environment into the room where it will be used,
condensation may occur. In order to avoid damage to the de vice, wait before preparing
it for use until the device has reached the ambient temperature and it is absolutely dry.
Fujitsu 15
To Next Page
Loading...
