System expansions
Securing the bottom casing cover
1
2
► Place the bottom casing cover on the device (1).
► Slide the bot tom casing cover in the direction of the arrow (2) until it engages noticeably.
► If you are using a latching clip and a padlock t o protect the device, close the latching
clip and fasten the lock (refer to "
Using a locking slide" , Page 53).
or
► If you are usin
g a latching clip and a Kensington Lock cable to protect the device,
close the latc
hing clip and fasten the Kensington Lock cable (see "
Using a locking
slide", Page
53 and "Using the security lock", Page 52).
► Position the device the correct way u p again.
Installing and rem oving additional memory
Memorymod
ule
Mainmemor
y
Memoryexp
ansion
Systemexp
ansion
Systemexp
ansion
Please obs
erve the safety notes in the ""
Important notes", Page 15" chapter.
When inst
alling/removing memory modules, t he device must not be connected to
the power
supply, refer to "
Preparing to remove components", Page 65.
Use only m
emory modules for expansion that have been approved for your
device,
refer to chapter "
Technical d ata", Page 101 .
Never u
se force when installing or removing memory modules.
Make su
re that foreign objects do not fall into the memory expansion slot.
You must open the service cover to r emove or install the m emory module.
The following description is identical for both memory m o dules.
98 Fujitsu
To Next Page
Loading...
