10 In the same way, repeat Step 3
through Step 9 to specify the IP address of the other LAN card (B in
Figure 8.1) on the server and the IP address of "CM#1 CA#0 Port#0" (D in Figure 8.1) for the ETERNUS
AF.
11 On the [iSCSI Initiator Properties] screen, click the [Targets] tab.
Confirm whether the specified contents in [The system will look for Targets on following portals] have
been applied correctly before checking connection.
Chapter 8 SAN Connection Settings
8.2 Server Connection Setup
123
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AG-1832-04ENZ0
To Next Page
Loading...
