Fujitsu ETERNUS AF250 S2 - Component Expansion;Function Enhancement; Installing Additional Drives

2 Connect a host interface cable to the
ETERNUS AF.
Insert the host interface cable connectors in the host interface ports (iSCSI) of Controller 0 (CM#0) and
Controller 1 (CM#1).
Do
• When connecting the host interface cables, position them so that they will
not obstruct replacement of the power supply unit or controllers by the main-
tenance engineer.
3 Connect the host interface cable to the connection destination.
Connect the other end of the cable to the connection destination.
4.2 Drive Enclosure Connection
When a drive enclosure is installed, connect the drive enclosure to the controller enclosure with a mini SAS
HD cable between enclosures.
0.75m mini SAS HD cables between enclosures are provided with drive enclosures.
The following procedure explains how to connect the mini SAS HD cable between enclosures.
Chapter 4 Connecting Cables
4.2 Drive Enclosure Connection
47
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AG-1832-04ENZ0