Fujitsu ETERNUS AF250 S2 - PC Terminal Connection; Figure 5.3 PC Terminal Connection for Initial Setup

5.1 PC Terminal Connection
Connect a PC terminal to the ETERNUS AF.
Connect the PC terminal to the RMT port of Controller 0 (CM#0) on the controller enclosure directly with the
LAN cable (for operation management).
For the setup information of the PC terminal, refer to "3.3 Preparing the PC Terminal for Setup
" (page 40).
The ETERNUS AF and the PC terminal must be connected directly since the network environment of the
ETERNUS AF is set using the PC terminal for the initial setup of the ETERNUS AF.
Figure 5.3 PC Terminal Connection for Initial Setup
PC terminal
LAN cable
LAN port
RMT port of Controller 0 (CM#0)
Controller enclosure
Chapter 5 General Settings
5.1 PC Terminal Connection
58
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AG-1832-04ENZ0