Fujitsu ETERNUS AF250 S2 - READY LED Not On; FAULT LED On

A confirmation screen appears.
5 Click the [OK] button.
The RAID group is registered and the registration completion screen appears.
6 Click the [Done] button.
The screen display returns to the [RAID Group] screen.
7 After creating an operation RAID group, repeat Step 1
and later steps to create a backup RAID group.
5.7.2 Operation Volume Creation
Create volumes (areas in the drives of a RAID group) in the RAID group.
Create a 1TB Standard volume in the operation RAID group created in "5.7.1 RAID Group Creation
" (page 74).
Figure 5.8 Operation Volume Creation
Operation RAID group (RG0)
Operation volume
RAID1+0 (2+2)
main
(Standard)
1TB
3.84TB
3.84TB
3.84TB
3.84TB
Chapter 5 General Settings
5.7 RAID Configuration Settings
76
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AG-1832-04ENZ0